Below are a few helpful articles that can help you get started using MatterControl.
|This article will help walk you through installing MatterControl. You can install MatterControl onto your desktop or laptop computer from the SD card that comes with the printer. The article also contains a link to directly download it from the website.
|This article will walk you through connecting MatterControl to your R1+.
This article will help you load files using MatterControl. It will show you how to print through either direct connection or SD card. (SD card is recommended so that you do not have to keep your computer connected for the entirety of the print.)
This article outlines where the slice settings are located within MatterControl.
This article shows you where the motor, speed, and extrusion controls are within MatterControl.
This article shows you how to manually change your Z-Offset.
This article shows you where and how to adjust the temperature of your hotend and print bed.
|This article shows you how to preview your print. Preview your print to observe its print orientation.