If, after running automatic calibration, you would like to adjust the z-axis offset either closer to the build plate (in case of prints not sticking) or further away from the build plate (in case of prints being too hard to remove and/or not printing), follow along with this video.
To Adjust the Z-Axis Offset, first, start a print.
While the printer is pre-heating, click on the icon that looks like a piece of paper on the right side of the screen. Then, click on the pencil button in the top right corner.
Adjust your Z-Axis Offset values either up (to increase the distance) or down (to decrease the distance.)
If your prints are sticking too well to the build plate, we recommend starting by setting the z-axis offset to 0.3mm.
Once you've adjusted your print settings, click on the checkmark to set them and then back on the build icon to return to the printing page. These settings will remain in effect until a factory reset is run. You may need to do a little trial and error to get the value just right.
Comments
0 comments
Please sign in to leave a comment.