Using print bed adhesion

Using print bed adhesion

The Robo R2 comes with a Buildtak adhesion plate to make sure your prints stick to the build plate with enough grip to hold the material on tightly.

• In order to make sure you get good adhesion of your print, make sure to wipe the print bed adhesion with a damp cloth before every print.
• If your prints have a hard time sticking to the bed, you can use a method to roughen the surface by using a 2000 grit sand paper and lightly sanding the top surface then cleaning off with a damp cloth. Make sure to run the Z Offset wizard after doing this.