Initial set-up
Now let’s move forward with your initial set-up of Robo C2.
First, insert the spool holder into the rear slot of the printer. Make sure the taller tab is inserted first.
Next, insert the filament feed tube into the filament sensor block, and then insert it into the extruder.
Inside the toolbox you will find the hotend cover. Go ahead and take that out and place it over the hotend. It is held in with magnets so it just pops right in.
From here you’ll want to connect the power cord to the designated area on the back of the printer and then plug it into an AC outlet.
Now go ahead and turn on the printer.
Comments
0 comments
Please sign in to leave a comment.