RoboSupport
- Total activity 609
- Last activity
- Member since
- Following 0 users
- Followed by 2 users
- Votes 6
- Subscriptions 313
Activity overview
Latest activity by RoboSupport-
RoboSupport created an article,
Robo E4: Filament Guide Detached from Extruder Assembly
If your Robo E4 has the black filament guide detached from where it is supposed to connect to the extruder assembly, it typically indicates that a piece of plastic on the top of the extruder assemb...
-
RoboSupport created an article,
Printing over Wi-Fi using RoboPrint to One or Multiple Printers
RoboPrint can be used with USB or Wi-Fi. The Getting Started with RoboPrint video shows the USB option but if you need to print wirelessly, simply go into Tools/Multi-Machine Control. From this int...
-
RoboSupport created an article,
Robo E3 Pro - Replacing the Extruder Circuit Board
This video walks you through replacing the extruder circuit board on your Robo E3 Pro. You will need a Phillips head screwdriver, an Allen wrench, a scraper, needle-nose pliers, and a very small fl...
-
RoboSupport created an article,
E3 Pro: Replacing the Extruder Assembly
This video shows you how you can replace your entire extruder assembly. Before replacing this part, make sure you have tried the unclogging steps available in this article: Unclogging your E3 Pro F...
-
RoboSupport created an article,
Robo E4: Z-Axis Go Home Error
If you are receiving this error message on a brand new printer, please make sure you have removed the four screws holding the build plate in place that were placed there for safe transport. Removin...
-
RoboSupport created an article,
E3: Clearing Filament Stuck in the Tube
If you find you have filament stuck in the middle of the filament tube on your Robo E3, this video shows you how you can access and clear that stuck plastic. If you have a hard time pressing d...
-
RoboSupport created an article,
Robo E3 Pro: Grinding Noise when Calibrating, Homing, or Setting the Z-Axis Offset
If you are getting a grinding noise while calibrating, homing, or setting the z-axis offset, it may be because your bed-levelling servo assembly is not functioning. If the grinding noise is happeni...
-
RoboSupport created an article,
Robo E3 Pro - Prints Stair-Stepping Side to Side or Shifting Mid-Print
If you are experiencing prints where it is stair-stepping side to side or shifting to one side or the other while printing, there are a couple things to check for. First, make sure your filament ...
-
RoboSupport created an article,
Robo E4: Clearing a Tough Clog - Aka Taking the Extruder Apart
This video shows you how to take the extruder apart to get to the toughest clogs. Prior to following these steps, we recommend following the guidance in this article for basic unclogging steps: Rob...
-
RoboSupport created an article,
Robo E4 Pro - Replacing the Circuit Board in the Extruder Assembly
This video shows how to replace the circuit board found inside the extruder assembly on your Robo E4 Pro. You may need to replace this part if the limit switches or movement of your 3D printer are ...