RoboSupport
- Total activity 641
- Last activity
- Member since
- Following 0 users
- Followed by 2 users
- Votes 6
- Subscriptions 325
Articles
Recent activity by RoboSupport Sort by recent activity-
Checking R2 bed pogo pin functionality
Checking the R2 pogo pin functionality If you notice that your bed seems to be heating up too slowly or your print bed is not being recognized check that your pogo pins are functioning properly. St...
Download OctoPrint Logs for Support
The OctoPrint Logs will enable our support team to better diagnose your problem and help get your Robo up and printing ASAP! Once on the Robo Dashboard, navigate to Settings at the Top right of the...
Things to check before every print
Things to check before every print on the R1+ To maintain a healthy printer, be sure to check for the following before every print: The print bed is free of any and all objects Nothing is blocki...
Controls
Controls for the R1+ The CONTROLS tab is where you can physically control your printer through the software. Here you can preheat your extruder and heated print bed, and even adjust your print spee...
What's in the box
What’s in the R1+ box Besides your new Robo R1+, you will find the following in the box: Setup instructions Power cable USB cable Spool holder Toolbox with lubricant, screw driver, allen wrenches,...
IR Sensor Basic QC
The R2 and C2 use an infrared sensor located behind the hotend (under the hotend fan) for sensing the distance to the bed for auto-leveling purposes. When the sensor is tripped, the bottom right co...
Writing an image to your SD Card
Instructions for writing the RoboOS Image to your SD Card: You will need to use an image writing tool to install the downloaded image on your SD card. Etcher is a graphical SD card writing tool ...
Fine tuning the Z-Offset
Fine tuning the Z-Offset If you are experiencing the nozzle dragging (too low) or your prints are not sticking (too high), you can find the perfect height using the Fine Tune Z-Offset Wizard. Your...
Overview
Overview of the Robo iOS app Thanks for downloading the Robo app! We're excited to show you all of its capabilities. Within the app, you're able to Connect to your local Robo C2 or Robo R2 3D prin...
Monitor your print
Monitor your print From the web dashboard, you are able to monitor your print, as well as start, pause, and cancel a print. In the top left of the interface under ‘state’, you will find information...