RoboSupport
- Total activity 640
- Last activity
- Member since
- Following 0 users
- Followed by 2 users
- Votes 6
- Subscriptions 327
Articles
Recent activity by RoboSupport Sort by recent activity-
Black screen on start up
Black screen on R2 start up The first step is to make sure the HDMI is properly connected to the Raspberry Pi and to the LCD Screen. Your HDMI cable may look different than pictured, but the loca...
Installing heat bed V2
1. Raise the bed a little over half way up the Z axis. You can do this manually by twisting the threaded rod in the clockwise direction, or from the Motor Controls on the printer touchscreen (aroun...
Gantry alignment
R2 gantry alignment 1. Start by printing out four of these gantry alignment tools. Note that these are not the same tools that the printer came packaged with, although those can be used as well. ...
Servicing Extruder Assembly
Removing Extruder Assembly In the case that you need to remove your Extruder assembly follow these steps. NOTE: Images are of a C2, but the steps for assembly for the R2 will be mainly the same. ...
Servicing Extruder Assembly
Removing Extruder Assembly In the case that you need to remove your Extruder assembly follow these steps. Remove the Extruder Cap, unlatch the extruder cable, and unplug the extruder power cable. ...
Replacing your MicroSD
In case you need to swap our your MicroSD card follow these steps. Note: Make sure your printer is off! 1. Remove the front bezel using both hands to pull down the top and then pull out the sides....
Replacing your MicroSD
In case you need to swap our your MicroSD card follow these steps. Raise your bed to give you clear access into the base of your printer. On the LCD Screen Navigate to Dashboard >> Motor Controls ...
Correct Shut Down Sequence
Make sure to follow the proper shut down procedure to help keep your machine running smoothly. Do not turn off the back power switch before running the on-screen shut down sequence. 1. On the print...
Correct Shut Down Sequence
Make sure to follow the proper shut down procedure to help keep your machine running smoothly. Do not turn off the back power switch before running the on-screen shut down sequence. 1. On the print...
Checking R2 bed pogo pin functionality
Checking the R2 pogo pin functionality If you notice that your bed seems to be heating up too slowly or your print bed is not being recognized check that your pogo pins are functioning properly. St...