RoboSupport
- Total activity 640
- Last activity
- Member since
- Following 0 users
- Followed by 2 users
- Votes 6
- Subscriptions 327
Articles
Recent activity by RoboSupport Sort by recent activity-
Replacing R1+ Plus nozzle tip
Taking off the nozzle tip on a hotend is fairly simple.Take out the hotendHeat it upLoosen Nozzle tipReplaceOn the R1+ you will need to use the Quick Release1) Loosen the quick release screw2) He...
Cooling
Cooling Enable print cooling Cooling fans are essential when printing with certain materials. Print cooling will make sure that the previous layer of material that is extruded is cooled enough s...
E4 Nozzle Snapped in Half or E4 Can't Insert New Nozzle
If you have run in to your Robo E4 snapping a nozzle in half, DO NOT simply replace the nozzle and try again or it will continue to happen. Instead, remove the snapped nozzle if you have not alread...
Files are not showing up on my Robo E4 Pro when trying to print from a USB flash drive.
If your 3D models aren’t showing up on your USB stick, first make sure you have them in the correct file format. The 3D printer cannot read a .stl or .obj file. It must first be sliced using a slic...
E3 Pro: Replacing the Left-Side Fan on the Extruder Assembly
If you need to replace the fan on the left-hand side of your Robo E3 Pro extruder, follow along with this video. Expect this process to take between 5 and 10 minutes. You will need:2mm Allen Wrench...
E3: Abnormal Temperature Error
The "Abnormal temperature" error indicates that the extruder sensor can not be read. Please check that the nozzle is correctly installed. Use your fingers or a pair of pliers to try to push the ext...
Video camera monitoring
Video monitoring within the app If you have an R2, your printer comes with an integrated camera so you can monitor your prints remotely via your mobile device. To set this up in the app, all you ne...
Using an adhesive on the print bed
Using an adhesive on the R1+ print bed To ensure the plastic print sticks to the glass print bed, you can use an adhesive. There are a couple of different techniques for prepping your print bed. Tw...
Starting your first print
Starting your first print on the R1+ To start your first print. You can either load your own file, or choose one of the preloaded prints inside the local library. To print one of the preloaded file...
Improve extrusion and prevent clogs
Here are a number of ways to prevent a clog or improve extrusion.1) Always extrude at the filament manufacturers temperature specs.2) Always heat up the hotend to the recommended filament temps whe...