Avatar

Debbe Hendrix

Follow
  • Total activity 5
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 2

Activity overview

Latest activity by Debbe Hendrix
  • Avatar

    Debbe Hendrix commented,

    1. Robo R2
    2. Troubleshooting
    3. Screen goes unresponsive or doesn't work

    I am trying to access the link to replace the files on my SD card but it says I’m not authorized.

  • Avatar

    Debbe Hendrix commented,

    1. Community
    2. General Discussion
    3. connection interrupted

    I’ve had this issue for two different reasons. One time because my z offset got screwed up and was way too low. It pushed the front of the bed down which disconnected the back of the print bed. The...

  • Avatar

    Debbe Hendrix commented,

    1. Community
    2. General Discussion
    3. Filament out

    Mine did the same until I change which side of the filament sensor the filament went through. Make sure your filament is going through the outer hole on the sensor. The hole on the right if you are...

    • View comment
    • Debbe Hendrix
    • -1 votes