RoboSupport
- Total activity 640
- Last activity
- Member since
- Following 0 users
- Followed by 2 users
- Votes 6
- Subscriptions 327
Articles
Recent activity by RoboSupport Sort by recent activity-
Start a print
Start a print Starting a print from your internal storage Select ‘Files’ from the home screen Choose between Local or USB Storage. And Select a file Now select ‘Start’ to print - and be sure to w...
Loading and Unloading filament C2
Loading and Unloading Filament Loading Filament From the home screen select ‘Utilities’ Next, select ‘Wizards’ Select ‘Filament Loading Wizard’ After you printer heats up, ensure you’ve cut the...
Error - Connection interrupted
'Connection Interrupted' error This connection interrupted error is a result of the main electronics board not being detected. There are a few ways this can happen - more discussed below. 1. First ...
Replacing the door on your R2
Replacing the R2 door If you have received a replacement door for Robo R2, follow these quick installation steps to have you back up and running in no time. First remove the original door. It is e...
Z-limit switch replacing
Z-Limit Switch Replacing If your Robo R2 seems to be not homing correctly when the print bed moves all the way to the bottom of the printer, you may have a faulty z limit switch. In order to replac...
Print bed pogo pin connection replacing
Print Bed Pogo Pin Connection Replacing If your Robo R2 gives you an error of your print bed not being recognized, even though it is on the printer, and seated properly, you may have to replace you...
How to update R2 firmware
Update the R2 firmware You can update from both the web dashboard and the touchscreen. NOTE: Before updating the firmware, make sure that your RoboOS is up-to-date by connecting your printer to th...
Error - Filament runout
Filament Runout Sensor Error If you see an error while printing Make sure you are not bypassing the filament block In order for the filament sensor to work correctly, the filament needs to be ru...
Drive gear aligning and tightening
Drive gear aligning and tightening If your drive gear has come loose and/or it is not aligned with the filament feed pathway, take these steps to realign and tighten. Note: Make sure there is no fi...
Hotend cover is falling off
Hotend Cover is falling off If your hotend cover is falling off when printing, or is teetering side to side and not flat against the extruder, more that likely your hotend is blocking it. To fix th...