RoboSupport
- Total activity 640
- Last activity
- Member since
- Following 0 users
- Followed by 2 users
- Votes 6
- Subscriptions 327
Articles
Recent activity by RoboSupport Sort by recent activity-
Print status
Print Status There are three ways to check on the status of your print while your Robo R2 is at work printing away Screen While your Robo C2 is printing, you can simply check the status by selec...
Start a print
Start a print Starting a print from your internal storage To create your print Select FILES on the home screen. Then select a file to print from the list. Now, select START to print—and be sure to ...
Loading and Unloading Filament
Loading and Unloading Filament Loading filament Now, unhinge the spool holder by simply pushing on the top of the higher lever from the rear of the printer. Next, insert the filament feed tube into...
Display Screen
The color touch screen display on the front of your Robo R2 is the main access point for setting up, controlling, and reviewing all components of your 3d printer. You can navigate through the menus...
Using Hotspot Mode
Using Hotspot Mode Your printer is capable of starting If no Wi-Fi signals are available for connection, you can use Hotspot Mode to emit a Wi-Fi signal from Robo C2 in order to connect to it wirel...
Removing the test print
Removing the test print When the test print is complete and cooled down, remove the print bed with the finished print still in place by lifting the bed up and away from the magnets. Slowly slide th...
The test print
To create your first test print 1. Make sure you've ran the Z offset Wizard and the Filament Loading Wizard. 2. Select Files >> Local >> Choose R2_Test_Print.gcode 3. Now, select START to print—a...
Loading Filament
Loading filament To begin loading filament, hang your filament spool on the spool holder. Be sure to unroll at least 11”— or 30 centimeters — of filament and thread it through the base of the filam...
Calibration and setting Z-Offset
Calibration and setting Z offset 1. Navigate to the Z-Offset wizard on the touchscreen under Utilities>Wizards>Z-Offset Wizard. 2. The bed will raise and the extruder will move to the front left p...
Updating Robo C2
Updating Robo C2 NOTE: R2 Screen is pictured, but the steps are the same for both C2 and R2. If you're not already connected to Wi-Fi, please navigate to Utilities > Network > Configure Wi-Fi befo...