Avatar

RoboSupport

  • Total activity 456
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 1 user
  • Votes 6
  • Subscriptions 232

Articles

Recent activity by RoboSupport Sort by recent activity Recent activity Votes
  • Troubleshooting INDEX (R1+)

    Look below for the problem that best describes what you are experiencing. The table beneath each header will contain links to helpful articles and some tips.  'Extruder not heating up' Tips & L...

  • Screen goes unresponsive or doesn't work

    Screens Goes unresponsive or Doesn’t Work If the screen is not working there is a few steps that need to be taken to solve the issue. 1. Loose Wiring  * First, raise your bed by manually turning th...

  • Material not extruding

    Material Not Extruding Nozzle isn’t heating up Make sure all of your wiring is plugged in and firmly mounted in its correct brackets. Nozzle Wires should be plugged into the correct terminals ...

  • How to PID tune your printer temperature

    If your print bed or extruder oscillates 2-3°C around the target temperatures you should follow this guide to help your printer stabilize the temperature variance.  Tuning your PID settings on your...

  • Print bed pogo pin connection replacing

    Print Bed Pogo Pin Connection Replacing If your Robo R2 gives you an error of your print bed not being recognized, even though it is on the printer, and seated properly, you may have to replace you...

  • Error - Connection interrupted

    'Connection Interrupted' error This connection interrupted error is a result of the main electronics board not being detected. There are a few ways this can happen - more discussed below. 1. First ...

  • Display Screen

    The color touch screen display on the front of your Robo R2 is the main access point for setting up, controlling, and reviewing all components of your 3d printer. You can navigate through the menus...

  • Material not extruding C2

    Material Not Extruding Nozzle isn’t heating up Make sure all of your wiring is plugged in and firmly mounted in its correct brackets. Nozzle Wires should be plugged into the correct terminals ...

  • Extruder not heating up.

    Hotend wires should be plugged into their correct ports on the underside of the extruder. The heater core is the red covered pair of wires, and the thermistor is the black pair of wires.  Make sur...

  • Installing New R1+ Heatbed (V2)

    Follow these steps to install a replacement print bed on your R1+ printer.  First, check to see if what version of the bed you have. If your bed cable does not have an exposed black connector as pi...