Avatar

RoboSupport

  • Total activity 456
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 1 user
  • Votes 6
  • Subscriptions 232

Articles

Recent activity by RoboSupport Sort by recent activity Recent activity Votes
  • Using Hotspot Mode

    Using Hotspot Mode Your printer is capable of starting If no Wi-Fi signals are available for connection, you can use Hotspot Mode to emit a Wi-Fi signal from Robo R2 in order to connect to it wirel...

  • Drive gear aligning and tightening

    Drive gear aligning and tightening If your drive gear has come loose and/or it is not aligned with the filament feed pathway, take these steps to realign and tighten. Note: Make sure there is no fi...

  • Replacing your Robo R2 Hotend

    Replacing your R2 Hotend Nozzle Follow these steps to remove your hotend nozzle NOTE: Make sure your hotend is cooled down before proceeding.  1. Make sure to turn your Robo R2 off, and unplug the ...

  • Printing and Installing Filament Guide Tube Clips

    PTFE Filament Guide Tube Clips provide your filament tube a secure location on your printer, and bring two guiding paths into one. Follow the simple step-by-step guide on printing and installing yo...

  • Mod your C2 with a 3D printed fan duct

    If you are wanting more air flow while printing with your Robo C2 or R2, follow this step-by-step guide to uninstall your stock fan duct, and install your shiny new 3D printed fan duct with no extr...

  • Troubleshooting INDEX (R2)

    Look below for the problem that best describes what you are experiencing. The article title in the tables below will link to the listed article, which contains helpful tips and solutions for each i...

  • Installing heat bed V2

    1. Raise the bed a little over half way up the Z axis. You can do this manually by twisting the threaded rod in the clockwise direction, or from the Motor Controls on the printer touchscreen (aroun...

  • How to update C2 Firmware

    Update the C2 firmware You can update from both the web dashboard and the touchscreen. (R2 Screen is picture but process is the same for the C2)  NOTE: Before updating the firmware, make sure that ...

  • How to update R2 firmware

    Update the R2 firmware You can update from both the web dashboard and the touchscreen.  NOTE: Before updating the firmware, make sure that your RoboOS is up-to-date by connecting your printer to th...

  • Installation and setup

    Installing and Setup Starting Cura for Robo for the first time After installing Cura for Robo, go ahead and open the application from your applications folder (or wherever you have installed it)...