I haven't used by Robo3d R1+ in a few months. I'm using version 1.7 of matter control.
I change the filament by preheating the extruder to 210. Then, I preheat the bed to 70. Temperature seems stable.
However, when I try printing, the bed termperature starts rising (I think the extruder falls to 200) and it won't start printing til the bed temperature reaches 90.
The print goes through fine, but the bed was at 90 and the extruder at 200 during this even though during the preheat was 70/210.
It's almost as if Matter Control inserted some temperature control gcode.
Please sign in to leave a comment.