Dismount Extruder Instructions

Comments

3 comments

  • Avatar
    Michael

    Hi Gary, 

    I'm sorry to hear that. Which unit do you need these instructions for? R2/C2/R1+ ? 

    0
    Comment actions Permalink
  • Avatar
    Gary Lindner

    R1+, purchased late last year.  Thanks.  Gary

    0
    Comment actions Permalink
  • Avatar
    Ray Fox

    My question is why did this happen.

    First, home the bed, then I used the temp control to reheat the nozzle (slightly higher than regular settings). When the extruder reaches target, the mess will release fairly cleanly. Next using a small razor knife, clean the nozzle and heat unit, then a damp cloth to clean the rest. Finally, unload and reload filament. Make needed adjustments so as not to repeat problem. (z-offset, hairspray, etc.

    0
    Comment actions Permalink

Please sign in to leave a comment.